- This topic has 8 replies, 3 voices, and was last updated 15 years, 11 months ago by
.
-
Posts
-
I am fairly new and cannot seem to get over the hurdle of not being able to simply ride the board straight- i.e. pointed down.. and not catch an edge and fall.. hard.. would like to be able to transition to being able to ride straight and moving from edge to edge for balance.. any hints?
Because mountains are never flat, trying to go down a run “flat bottomed” is pretty hard. The more experience you have riding, the easier this is, but for just starting out, what you want to do isbe slightly on one edge and transfer to the other. What I'm talking about isn't so much turning,but just staying enough on your edges to have control.A good way to learn how to make a direct line, is to start out with wider sweeps andwork your way inward.Try using something like…a 10 foot width going down the mountain to start off. go onyour toe side 10 feet in that direction, then on your heelside 10 feet to the other direction.You'll be going pretty straight down the mountain, with just enough turns to make sure youalways have an edge in control.As you get used to this transfer and the speed of going straight down a run, you can startkeeping your boWelcome Duckie. I think narrow flats are really hard, but can be mastered with practice. Here are a couple tips:1) Most flats ares are not truely flat. Typically there cut into the side of the mountain and one side is the uphill side and the other the downhill side. For reasons of drainage and erosion, the uphill side is usually slightly higher than the other. Try to head down to the downhill side only to gain speed, then use that momentum to edge slightly back to the uphill side. Try to stay on the uphill side as much as possible. That way if you fall, you can get back going easier.2) Do not try to ride flat base. There is no control that way. If you need to go mostly straight but still stay in control, use the torsional flex in the board to edge only the edge on the back foot and leave the front foot part of the base flat. YOU WILL LOVE THIS ONE —Thanks very much to both posters.. these both sound like great suggestions and exactly what I've been trying to get answered.. I get freaked out when I have to traverse a narrow section because I have no room to make those wide turns I am comfortable with- maybe it's the speed factor, I don't know, also the small nuisance of catching an edge and falling hard every time I try to go straight! Those tips should really help.. thanks!
if you get into a situation where you dont feel comfortable going straight down like that,theres always the option of doing a “stall” where you go down straight, butthe board is sideways. if you know what i mean.i use this route when i get stuck on a cliff or something and need to go down slowlybecause i dont know whats right under me.from what it sounds, you're picking things up very quickly. how long have you been riding?these are more intermediate questions, so you must have small carving down, right?
yes I am a Stall Master. I'm so good at it sometimes I ride it down the mountain. Been riding intermittently for a couple of years.. need to do it more consistently.. if time will allow..by small carving you mean…?
small carving, slow leaned in turns from side to side without gashing the mountain.its just something i call it when im inbetween turning and hard carving.have you hit any jumps yet?
maybe very small jumps.. but nothing really.. don't have the small carving technique down as I'd like either .. have the falling on attempt down pretty well
- You must be logged in to reply to this topic.