- This topic has 4 replies, 2 voices, and was last updated 17 years, 9 months ago by
.
-
Posts
-
Hi, I really hope you can help me. I am a beginner’s snowboarder trying to find the right board and bindings. I am 5 feet, 10.5 inches tall, 200 pounds, size 12 (maybe 12.5) boots, a 46 year-old man. I just want to get down the mountain smoothly doing smooth turns. I don't want to jump rails or boxes, just enjoy a smooth hill. I thought I was progressing on rented equipment here in southern California. After my third trip to the mountains, I bought equipment. I bought a Ride Fleetwood Wide board, 158 CM long and 265mm waist per the sticker on the board. I also used Burton Cartel bindings and size 12 Burton Moto boots. On my first trip, I could not control this darn board!, it felt huge and unruly compared to the rental snowboards. I body slammed a couple times which did not really happen with the rented boards. Also, I finally tried heel side edg
Sounds like good gear. Could be a couple different things.1) Conditions. They always change. It would be difficult to go into it very far, but just let me express that EVERY day out the conditions will be different. Some conditions make you a hero and others make you a fool.2) Fit and configuration. You mentioned about your “My toes got smashed and and pinched”. This is not good. It could be due to a few different things. Please reply with a description of your boots and how they fit and feel when on and laced up good. Next, strap a boot into the binding and tell me how much your toe overhangs and heel overhangs specifically.Additionally, I would not recommend MAX stance width setting. Yes, a wider platform provides you stability but may hinder flexibility and range of motion.I look forward to your reply.
Hi againI ride regular foot, not goofy. My rear boot extends one inch over the heel and one inch over the toes. My front foot hangs a bit less because I cant that one about 15 degrees forward. I wear Burton Moto boots. These are the ones with the boa system. They have the thin pull cords, not the BOA twist knob. I was advised to pull the chords very tight. I was told by the salesman that these are a relatively soft boot. Originally, I had Burton Cartel bindings with the toe strap. But those were cramping my toes. Yesterday I bought some Ride “Beta” bindings. These have the strap going over the instep. This strap can be converted to a toe strap. You can use the front strap on either the toes or the instep. The salesman also suggested I buy the Burton “Elevator” plates. These are two spacer plates. One goes beneath each binding. TheI forgot to add: when I lace them tight as suggested, they are quite constricting. I have to loosen them often because my feet fall asleep.
Hi againI ride regular foot, not goofy. My rear boot extends one inch over the heel and one inch over the toes. My front foot hangs a bit less because I cant that one about 15 degrees forward. I wear Burton Moto boots. These are the ones with the boa system. They have the thin pull cords, not the BOA twist knob. I was advised to pull the chords very tight. I was told by the salesman that these are a relatively soft boot. Originally, I had Burton Cartel bindings with the toe strap. But those were cramping my toes. Yesterday I bought some Ride “Beta” bindings. These have the strap going over the instep. This strap can be converted to a toe strap. You can use the front strap on either the toes or the instep. The salesman also suggested I buy the Burton “Elevator” plates. These are two spacer plates. One goes beneath each b
- You must be logged in to reply to this topic.